McTrinsic wrote: ↑
Mon Jun 22, 2020 2:18 am
Could you a bit more I to detail what you did?
Would be interested to see what we can do about this.
How did you
- set termination
- provide power to the SCSI2SD
I had some time to work on this.
I managed to hook up the SCSI2Sd card to my computer and using the SCSI2SD-util program I updated the firmware and created one 2gig partition.
I then hooked the card up to my Dataflyer scsi card and booted with a 3.14 install disk. I tried hdtools but it did not recognize the hard drive. I booted from a dataflyer install disk same thing it did not recognize the HD.
Power is being provided by a floppy power source.
I can’t see a way to terminate the HD. It’s the only HD in the computer.