So I am in the process of restoring an Amiga 1000 and had no clue what was inside, jus that it didnt work.
It wouldn't boot, had a green screen. So I removed the ram expansion pack, the 1MB DKB Insider and the KwikStart II with a single Kickstart ROM, jumpered to ROM.
Just got a monochrome gray screen.
So read up on the KwikStart II, apparently it replaces a PAL chip 6J.
"This Pal is to be installed on the daughter board of your Amiga®. The PAL is labeled KwikStartTM V2.X. This Pal is for use with V2.0 and will also work with Vl.3 or Vl.2 KickstartTM. This Pal must be installed on the daughter board of your Amiga® for the KwikStart IITM to work."
So I wired up only the KwikStart II (Two Solder Points), no DKB Insider 1MB or the RAM expansion pack and the system boots to the insert workbench screen.
So the question I have is am I stuck with KwikStart II? I of course dont have the orginal PAL chip 6J.
Is there somewhere I can get this chip contents and program my own GAL perhaps?