User avatar
EzdineG
Springfield, MO

Posted Fri Apr 09, 2021 5:29 pm

JoeUser wrote:
Fri Apr 09, 2021 4:32 pm
The only confusing part of the earlier instructions were with step 3, I didn't see where anything was connected to the chip in the photo (and a wire run to somewhere?).
The green wire on the lower right of the photo is "connected" to pin 13 U6L, but instead of tapping it directly off a pin on the chip I used the nearest VIA on the motherboard that was physically connected to the same place. The other side of that wire needs to connect to J1 on the board you just purchased.

Hope that helps

User avatar
JoeUser
Dallas, TX

Posted Fri Apr 09, 2021 8:19 pm

Ah, ok, thanks! So, switching between ROMs is keyboard controlled, then? Or do I have to install a physical switch?

Apologies for my questions, this will be the first time I've installed a switcher.





Return to “Hardware”