blindguy wrote: ↑
Tue Aug 11, 2020 1:17 pm
halfbrite wrote: ↑
Thu Aug 06, 2020 1:06 pm
Any one interested in me doing face up prints?
Where you located? I've been getting better results with top down but I'll give it a shot.
Boston, MA Would be curious to see how much work it is for clean up, however that being said, if your layering is not bad, doing vertical may be the best. What are your printer build dimensions?
If I have the time this week, I will spend it tweaking my bed, temps etc and see if I can get better face down prints. With my build surface, I will always have the mottling, well an even mottling
https://community.ultimaker.com/topic/3 ... er-of-pla/
Then you could of course sand it smooth.