I posted in another thread that wasn't relevant so starting it here:
My board so far is as good as it’s gets as far installation ready. So after a 1000 tries to insert into MB there are still a few gaps as far as those molex in center sliding all the way down. Do they absolutely need to seat to the black spacers?
Looks like amiga chips insert decently now but getting to absolute 100% fully down I just can’t get.
Greg Tibbs original manual mentions this is going to be a bear and would do it for you for a charge. Some here mention how much a pain this is but the German guy selling a bunch and Paul Rezendes say it is not a problem. Am i just being too cautious about applying enough force?
Of course due to my novice status I can’t wait to see the real issues that come up if I ever do get it installed.