@ Fantomen
please check your PM's
Thanks for your reply.fastrobplus wrote: ↑Fri Aug 26, 2022 10:14 amI either never knew or don't remember the answer, but would the extra height cause a clash with the case lid?
Either way, if it's a 8372B or 8372AB Agnus, you should be able to swipe it from the meg-a-chip and use it directly by changing jumpers and upgrading RAM on the Rejuvi, or if it's the 8375, by doing that plus this adapter board:
https://www.pcbway.com/project/sharepro ... aptor.html
I can tell you that the ACE2B does NOT physically fit in the Rejuvenator....I triedCrashMidnick wrote: ↑Thu Aug 25, 2022 2:31 pmHello there,
Do we know if a MegaChip can work with the Rejuvenator ?
Thanks.
Yes, I have removed the floppy and 4 screws from the board (2 next to the PSU and 2 from the front of the board) but still, something holds it attached.
So I assume that I need to remove those extra pins from the top of all of them as well those 3 plastic poles.intric8 wrote: ↑Wed Dec 28, 2022 6:29 pmOnce you have the motherboard removed entirely from the case, I can't recommend more highly that you get these 3D printed. It's almost impossible to mount the Rejuvenator on top of the golden pins without a guide of some sort. You'll print those then push them onto the tops of the pins and only push them down about .5 mm. You want the gold sticking out, but not too much. Then once all the holes are aligned (you should try to triple-check your alignment) you'll firmly push down on the Rejuve to get that thing to go down. And the guides will slide down the pins as you go. It's a PITA and the hardest part about the installation.
Also, as you push it down and get near the bottom, you'll very likely need to double-check the blue capacitors are going through the rectangular cut out. The tolerance is nil. Honestly, that's one part of the Rejuve I I wish could be redesigned so that gap wasn't so tight. Finally, make sure you don't bottom-out the bottom of the Rejuve onto the top of any of your components down below. The new design will ride really low, though, so don't worry that it seems to go all the way to the floor.
Yes, I got some extra left from my expansion board project for A500 as well got some on eBay.