Where can I find a bill of materials for this board?
Thanks.
I would recommend you build the newer (stickied) iteration of the board instead. The newer design fixes an issue that may turn up during manufacture and doubles as a kickstart switcher.Trekiej wrote:Where can I find a bill of materials for this board?
Thanks.
Are you using the board revision on this post, or the updated dual version?RocketRodent wrote:Hey all,
I've got one of these adapters that I can't seem to get to work. I noticed that everyone has either a rev A or B A1000. I have a NTSC rev 6 A1000 with a daughter card. I've installed this following the directions and only get a blank v-synced screen. I can reverse the install and get the machine to come back to a Kickstart request as expected.
Any ideas?
EzdineG wrote:Are you using the board revision on this post, or the updated dual version?RocketRodent wrote:Hey all,
I've got one of these adapters that I can't seem to get to work. I noticed that everyone has either a rev A or B A1000. I have a NTSC rev 6 A1000 with a daughter card. I've installed this following the directions and only get a blank v-synced screen. I can reverse the install and get the machine to come back to a Kickstart request as expected.
Any ideas?
It is possible your PCB is defective. The single ROM version here had an unused VIA in the line going to the daughterboard DAUGEN that may become a problem if it is a low quality fabrication (a few of my JLPCB batch of boards didn't work due to this.) I experienced this first hand with the PCB that I originally sent Intric8. This is a non-issue with the newer board linked above.
You can also try using an original MASK ROM instead of an EPROM, or vice versa. I may still have a dual kickstart PCB laying around if you need.
Hey, Joe! The instructions at the start of this thread should be all you need. Looks like that vendor pointed you right where you needed to be!JoeUser wrote: ↑Fri Apr 09, 2021 10:09 amI know this thread is a little dated, but resurrecting it briefly.
I just ordered the complete assembled board from here.
This appears to be Version 2, which I'm hoping is the latest and best board. If anyone else has purchased one of these, did it come with detailed instructions? I can rely on this thread, but wanted to make sure that what's posted here applies to this V2 board.
I also have a TF536 board that I'm hoping will work with the board, as well.
Many thanks for the thread, I'm looking forward to ditching the KS disk!