McTrinsic wrote: ↑Wed Nov 20, 2019 5:59 am
Just to clarify. My questions regarding (autoconfig) RAM is mid-term to ensure that 3.1.4 can run on the machine.
First we should solve the hardware-issues. Get the signals as EdzineG said to the board. Make sure it’s appropriately powered.
Then we can look at the software.
As of right now the computer can and will boot to 3.1.4 locally on the ram disk or kickrom. I'm going to attempt to power the SD IDE
EzdineG wrote:
I’ve attached a photo I’ve found from a while back when I installed the same board. OVR and INT2 are the yellow/green pair as attached to the version of the IDE68K I used (yours may have the pins in a different place) and the A1000 expansion connector. Note their location on the motherboard.
Thank you for the photo reference...
as much as I appreciate MKL's hardware his site is very difficult to navigate when looking for information.