UPDATE!!
The drive works!!! but...
I'm reading that it's caused by going over the 4GB partition limit? The partition set for DH0 for WINUAE was set to around 2000mb for this hard disk image.
Sadly it doesn't see the CF card when booting from floppy. This was the first screen that appeared after I got it to work. Will switch the INT2 and OVR and see what happens.
The error wont let me boot to the system tools. It's the first thing that shows up when turning on the Amiga.
I've had an order for a 4 inch cable in from China for a while on another project. Is the shorter the better?
I'll see if I can just wipe the SD and try installing it locally like you're saying. If all else fails, I might just buy another IDE device. Any recommendations that worked for you?EzdineG wrote: ↑Thu Nov 21, 2019 4:25 pmThe floppy should take precedence if one is inserted on power up. Use HDTOOLBOX from the floppy boot to repartition the drive and reinstall.
Try a different SD card, or get this into a Windows machine and use the diskpart clean command to wipe it. That, or as McT says you have a shite or too long IDE cable.