You can always stick a Vampire 500 V2 in there if you want to transform it completely, too.but it doesn't change the underlying old architecture of the A1000, which is what I'm looking for.
You can always stick a Vampire 500 V2 in there if you want to transform it completely, too.but it doesn't change the underlying old architecture of the A1000, which is what I'm looking for.
Tks, not a big fan of the FPGA route tbh, I'd like to keep it real and stick with the original chips. I could just use PiStorm+Emu68 if I wanted emulation.intric8 wrote: ↑Thu Jan 19, 2023 10:10 pmYou can always stick a Vampire 500 V2 in there if you want to transform it completely, too.but it doesn't change the underlying old architecture of the A1000, which is what I'm looking for.
If it ends up working and you build an extra, please add my amiga to your list of disk clicking excitement!geekpower wrote: ↑Sun Jan 22, 2023 4:03 pmI just placed an order for 5 Rejuvenator PCBs at PCBWay. I cannot express how excited I am to get them and start building! My Amiga 1000 is so excited right now, it's clicking its disk drive with more verve than usual - almost rattling my coffee mug off the desk.
Jack, any tips to share - were those IC connection wires correct? Did you populate a jumper in the position you found? Which kick rom did you end up using, or is the picture from a normal floppy-based kick session?JackTheKnife wrote: ↑Fri Dec 30, 2022 10:00 amAnyway - can someone post some high res pic where those clips should be connected to the ICs? PDF photo is not of great quality and I want to be sure I have connected to the right IC leg. Do I need to connect +12V as well or that is an option for the original Rejuvenator only?
Here is how I have it connected:
Also installation manual is talking about a jumper to set when Kickstart ROM is present but I'm not able to locate it (one empty hole but not a jumper). And should stick to 1.3 ROM on the board or go for 3.1 or something else?
Sorry for the late response. Yes, those connections are correct.luvwagn wrote: ↑Mon Jan 30, 2023 12:58 pmJack, any tips to share - were those IC connection wires correct? Did you populate a jumper in the position you found? Which kick rom did you end up using, or is the picture from a normal floppy-based kick session?JackTheKnife wrote: ↑Fri Dec 30, 2022 10:00 amAnyway - can someone post some high res pic where those clips should be connected to the ICs? PDF photo is not of great quality and I want to be sure I have connected to the right IC leg. Do I need to connect +12V as well or that is an option for the original Rejuvenator only?
Here is how I have it connected:
Also installation manual is talking about a jumper to set when Kickstart ROM is present but I'm not able to locate it (one empty hole but not a jumper). And should stick to 1.3 ROM on the board or go for 3.1 or something else?