Hi I don't have much experience whit Amiga accelerator and I was wondering if anyone out there could help me sort out the problem I have whit my GVP Impact A3001 I just acquired as it fail to boot and hang on a black screen.
Here the steps I taken already and things to note
-I removed the ram expansion board to be sure it did not interfere
-I looked up the jumper setting to make sure they were right
-They was some corrosion on the connector but I used a continuity tool to make check them
-They is not FPU on the board, I don't know if it need one to boot
-I removed the 68030, it had one bend pin but I repaired it
-They is a fallback jumper on the board and whit it the 68000 boot
-Tested whit and without the ide boot rom and the result was the same
Here the current state of the jumper
J1 - on
J2 - off
J4 - off
J5 - on
J6 - off
J7 - on
J9 - on
J10 - on
J11 - off
J12 - off
J13 - off
J14 - on
J15 - off
J16 - on
J17 - off
J18 - off
My Amiga is a 2000 Rev 6.2 NTSC whit 1mb of chip ram
If there any other detail you think I left out feel free to ask, it's my first time asking for help like that so I hope I did not forget anything.
Thanks a lot to anyone that will take the time to read this