IDE 68k in A1000

[Marchie]

Hey follks,

I’m installing an mkl 68k RAM/IDE board and to get the IDE working I need to connect to the OVR and INT/2 lines.

These are both on the expansion slot but I don’t want to solder wires to the motherboard unless I really have to.

INT/2 I can pick up from Paula, but OVR is proving hard to find, and schematics for the 1000 are pretty difficult to find/follow as well.

Does anyone know where I can find OVR on the A1000 motherboard? (On a chip I can clip to that is NOT covered by the Rejuvenator)?

Thanks in advance to anyone who can help!

[A10001986]

Apparently on pin 17 of the expansion connector.

[kippy]

The solder hole next to the CPU, the DPALEN Pin #7 on the actual Daughterboard (either the underside or topside), or pin #7 on the mezzanine riser at U6P. You could also use a clip line on the riser as well.

Hope this helps.
-Cliff